How to change table saw blade without wrench

A table saw is one of the most indispensable tools in the workshop of any woodworker. Not only are they versatile for a variety of projects, but they are also the best when it comes to making repeatable, accurate cuts.

However, in order to reap these benefits, the saw’s blade must be of the highest quality. At some point, you will need to replace the blade.

How to Change Table Saw Blade without Wrench?

Turning Power Off

Safety is probably the most critical consideration when working with power tools. As you can see, these are quite dangerous if not handled properly. You must ensure that your table saw’s power switch is turned off. Simply for added security, unplug it completely from the power outlet.

Allow it to remain that way for a time. As a result, the machine’s power supply can be completely depleted. At the end of the day, the best course of action is to avoid any accident, large or small. Therefore, ensure that you take all necessary precautions.

Removing the Blade and Covering Plate

Once the metal plate has been removed from the table saw, it is time to remove the saw blade. It will be easiest to remove the tool if you can raise it as high as possible. There is an arbor there that is primarily responsible for holding the table, saw blade, and Plate Covering. For the majority of table saws, the blade plate is located near the bottom of the power tool.

There are approximately two screws there for securing the blade plate over the blade. Simply unscrew those screws and remove the metal plate from that location. In this case, it is preferable to thoroughly review the table saw’s user manual. This will assist you in quickly locating the blade plate. Now store the screws and metal plate safely because they will be required to reassemble the table saw blade.

Attaching the New Blade

Simply place the new table saw blade in the same location as the old blade. When installing the new blade, extreme caution must be exercised to ensure that the new blade is positioned exactly in the same location as the older blade. You can also replace the arbor nut and washer if necessary, depending on their condition.

Once each element is snugly fitted, begin tightening them. When screwing them back in, be sure to rotate them clockwise.

Get Everything Back to Its Original Spot

Using screwdrivers reinstall the blade plate and tighten everything securely. Everything should be returned to its original location. Following that, connect the saw to a power outlet. Verify that the blade is running in the proper direction. If there is any difficulty, then engage in another session of dissembling to ascertain and resolve the issue.

Leave a Comment